Only question is: why did the profile have the right extruder trying to print, when it was supposedly turned off? I increased the wall thickness and infill as well for this model, but I think that skipping every other layer and sagging at the edges made it difficult to bridge between the front legs and the body. trace the entire model every other layer, so the left extruder still oozed on the part during this time. was off, the profile still had the right ext. I also added a fence ( which shouldn't really be necessary if only the left ext. So I went back to the profile and removed the temp controller for the right ext. Also both nozzles were drooling all over the part. In this situation the right extruder was trying do the infill, but was so minimal as to be useless in this case. controller specified so the program insisted on having some heat to the right ext. I thought that the right extruder would not be in play, but there was a temp. I have imported the profiles (thanks Jetguy!) and attempted a print using the Dual-Left-PLA profile.
0 kommentar(er)
